Which CNC System Should I Choose?

The selected CNC system functions of the CNC system are divided into basic functions and selection functions, which can be comprehensively measured from the aspects of operation mode, user function, control mode, drive form, feedback form, interface form, detection and measurement, alarm and prompt, fault diagnosis, etc. . The basic functions must be provided, and only when the user chooses the selected function, the manufacturer will provide it separately and increase the price, and the price is generally higher. In general, the functions of the CNC system must be selected according to the performance needs of the machining center. When ordering, you must order all the required functions without omitting them, and at the same time avoid waste caused by low usage rates. correlation. On the other hand, among the available CNC systems, such as the SIEMENS system, the FANUC system, the domestic Huazhong CNC system, etc., the performance is very different, and the price is also very different. The imported system or the domestic system also determines the price. In general, the Frank system is relatively cost-effective, and the domestic horizontal machining center has a relatively high proportion of use. There are also many horizontal machining centers in the station that use the Frank CNC system, such as MH-800B and LH-500B are better choices. When selecting multiple horizontal machining centers, the CNC system of the same manufacturer should be selected as much as possible, so that the operation, programming and maintenance are more convenient.